| CAUTION | If Engine Control Module (ECM) replacement is instructed in following test, always ensure ECM electrical connectors and ground circuits are okay. If either are defective, repair and repeat testing to confirm ECM malfunction. If ECM is replaced, ECM must be programmed with proper ignition key code for engine immobilizer system. For programming procedures, see COMPUTER RELEARN PROCEDURES article in GENERAL INFORMATION, or appropriate ENGINE IMMOBILIZER SYSTEMS article in ACCESSORIES & EQUIPMENT. |
Circuit Description
Fuel pump operating speed is controlled by operating condition of the engine such as: starting, idling, light load or heavy load. When engine is cranking and start signal is received at ECM, the ECM energizes circuit opening relay and voltage is applied to both sides of fuel pump relay. Fuel pump relay contacts are closed on one side and voltage is applied directly to fuel pump in which fuel pump operates at high speed. After engine starts during idling or light loads, fuel pump relay is energized by FPR terminal of ECM and contacts in fuel pump relay close to other side of relay. Voltage is then supplied to fuel pump by going from fuel pump relay through fuel pump resistor. Fuel pump now operates at low speed. DTC is set when ECM detects an open or short in a fuel pump relay circuit. Possible causes are
- Fuel pump relay circuit is open or shorted.
- Defective fuel pump relay.
- Defective ECM.
Diagnostic Aids
Using Toyota hand-held tester or scan tool, read FREEZE FRAME data. Freeze frame data records engine conditions when malfunction is detected.