Contents Wiring diagrams Section: Mechanical All sections

Engine Mechanical: Specifications Toyota Echo I

Mechanical 1 illustration

Crankcase Capacity

See CRANKCASE CAPACITIES table.

ENGINE SPECIFICATIONS

ApplicationSpecification
Displacement92 Cu. In. (1.5L)
Bore2.95" (75 mm)
Stroke3.33" (84.7 mm)
Compression Ratio10.5:1
Fuel SystemSFI

GENERAL SPECIFICATIONS

TORQUE SPECIFICATIONS

ApplicationFt. Lbs. (N.m)
A/C Compressor Bolt18 (24)
Axle Shaft Nut159 (216)
Ball Joint-To-Knuckle Nut72 (98)
Camshaft Bearing Cap Bolt (1)
No. 117 (23)
No. 2(2)
Camshaft Sprocket Bolt47 (64)
Connecting Rod Nut
Step 111 (15)
Step 2(4)
Crankshaft Pulley Bolt94 (128)
Cylinder Head Bolt (3)
Step 121 (29)
Step 2(4)
Step 3(4)
Drive Plate Bolt65 (88)
Engine Coolant Drain Union26 (35)
Engine Hanger At Cylinder Head Bolt28 (38)
Exhaust Manifold Nut20 (27)
Exhaust Manifold-To-Cylinder Block Brace Bolt27 (37)
Exhaust Pipe-To-Exhaust Manifold Bolt46 (62)
Exhaust Pipe-To-Tailpipe Clamp Bolt24 (32)
Flywheel Bolt
Step 136 (49)
Step 2(4)
Fuel Pipe-To-Cylinder Head Bolt14 (19)
Intake Manifold Bolt/Nut22 (30)
Knock Sensor29 (39)
Left (Transaxle Side) Engine Mount Bracket-To-Insulator Bolt36 (49)
Left (Transaxle Side) Engine Mount Bracket-To-Transaxle Bolt47 (64)
Main Bearing Cap Bolt (5)
Step 116 (22)
Step 2(4)
No. 1 Oil Pan Bolt18 (24)
Oil Filter Union22 (30)
Oil Pan No.1 Bolts18 (24)
Oil Pan Drain Plug28 (38)
Oxygen Sensor-To-Exhaust Pipe32 (43)
Plug At Timing Cover11 (15)
Power Steering Pump Adjusting Bracket Bolt32 (43)
Power Steering Pump Mounting Bracket-To-Cylinder Head Bolt32 (43)
Rear (Firewall Side) Engine Mount Through-Bolt36 (49)
Right Engine Mount Bracket-To-Timing Chain Cover Bolt41 (55)
Right Engine Mount-To-Body Bolt33 (45)
Right Engine Mount-To-Bracket On Cylinder Block Bolt/Nut38 (52)
Spark Plug13 (18)
Throttle Body Bolt/Nut22 (30)
Tie Rod Nut36 (49)
Timing Chain Cover Plug11 (15)
Torque Converter Bolt20 (27)
Valve Timing Controller Bolt47 (64)
Water Pump Pulley11 (15)
Wheel Lug Nut76 (103)
INCH Lbs. (N.m)
ABS Speed Sensor Bolt71 (8)
Air Cleaner Case Bolt66 (7.5)
Camshaft Position Sensor Retaining Bolt71 (8)
Clutch Release Cylinder Bolt106 (12)
Coolant Inlet Nut80 (9)
Crankshaft Position Sensor Bolt (8)
Bolt "A"66 (7.5)
Bolt "B"97 (11)
Ignition Coil Bolt80 (9)
Oil Pan No.2 Bolts80 (9)
Oil Control Valve Bolt71 (8)
Oil Pump Cover Bolt80 (9)
Oil Pump Cover Screw97 (11)
Oil Pump Strainer Bolt97 (11)
Outer Front Cowl Top Panel Bolt71 (8)
Timing Chain Cover Bolts (6)
A, C, E & G97 (11)
B, D & F(7)
Timing Chain Tensioner Bolt80 (9)
Timing Chain Vibration Dampener Bolt80 (9)
Valve Cover Nut89 (10)
Water By-Pass Pipe Bolt80 (9)
Water Filler Bolt66 (7.5)
Water Pump Bolt/Nut97 (11)
(1) Tighten bolts to specification in sequence. see scheme 10 (2) Tighten to 89 INCH Lbs (10 N.m). (3) Tighten bolts to specification in sequence. see scheme 5 (4) Tighten an additional 90 degrees. (5) Tighten bolts to specification in sequence. see scheme 16 (6) see scheme 8(7) Tighten to 18 Ft. Lbs (24 N.m). (8) Tighten bolts to specification in sequence. (Scheme 7)
(1)Tighten bolts to specification in sequence. see scheme 10
(2)Tighten to 89 INCH Lbs (10 N.m).
(3)Tighten bolts to specification in sequence. see scheme 5
(4)Tighten an additional 90 degrees.
(5)Tighten bolts to specification in sequence. see scheme 16
(6)See scheme 8
(7)Tighten to 18 Ft. Lbs (24 N.m).
(8)Tighten bolts to specification in sequence. (Scheme 7)

TORQUE SPECIFICATIONS

Scheme 7

Scheme 7