Code Definition
- DTC P0100: Mass Airflow Meter Circuit
- DTC P0102: Mass Airflow Meter Circuit Low Input
- DTC P0103: Mass Airflow Meter Circuit High Input
| CAUTION | If Engine Control Module (ECM) replacement is instructed in following test, always ensure ECM electrical connectors and ground circuits are okay. If either are defective, repair and repeat testing to confirm ECM malfunction. On models equipped with engine immobilizer, if ECM is replaced, ECM must be programmed with proper ignition key code for engine immobilizer system. For programming procedures, see COMPUTER RELEARN PROCEDURES article in GENERAL INFORMATION, or appropriate ENGINE IMMOBILIZER SYSTEMS article in ACCESSORIES & EQUIPMENT. |
Note. If DTCs related to MAF, IAT, TPS, ECT, HO2S and/or A/F sensor are output simultaneously, the E2 sensor ground circuit at ECM 34-pin connector E4 terminal No. 28 (Brown wire) may be open. See ENGINE PERFORMANCE in SYSTEM WIRING DIAGRAMS article in ELECTRICAL. For ECM connector terminal identification (Схема №9)
Circuit Description
Mass Airflow (MAF) meter uses a platinum hot wire which is maintained at a constant temperature by controlling the current flow through the hot wire. Current flow is then measured as an output voltage. MAF meter may also be referred to as airflow meter.