Home/Toyota/4Runner/Toyota 4Runner IV (2002-2005)/Repair manual/Suspension Front/Suspension System - Front: Other

Contents

Wiring diagrams Section: Suspension Front

All sections

Suspension System - Front: Other Toyota 4Runner IV

Suspension Front ~129 words

RIDING HEIGHT

For 2003 models, see SPECIFICATIONS & PROCEDURES article in WHEEL ALIGNMENT. For 2004 models, see SPECIFICATIONS & PROCEDURES article in WHEEL ALIGNMENT.

WHEEL BEARING

Note. Wheel bearing is press fit and no adjustments are required.

HUB & STEERING KNUCKLE

Note. For component view (Схема №1)- (Схема №4).

LOWER CONTROL ARM & BALL JOINT

Note. For component view (Схема №1)- (Схема №4).

CAUTION

Lower and bounce vehicle several times to stabilize suspension before tightening lower control arm shaft nut to specification.

LOWER CONTROL ARM BUSHINGS

Note. For component view (Схема №1)- (Схема №4).

STABILIZER BAR

Note. For component view (Схема №1)- (Схема №4).

UPPER CONTROL ARM

Note. For component view (Схема №1)- (Схема №4).

UPPER CONTROL ARM BUSHINGS

Note. For component view (Схема №1)- (Схема №4).

Note. Bearing cannot be reused. If bearing is removed for any reason, it must be replaced.