Cranking System Specifications
| Voltage | 12 V | ||||
|---|---|---|---|---|---|
| Output | 1.4 kW | ||||
| Rating | 30 seconds | ||||
| Direction of rotation | Clockwise as viewed from pinion side | ||||
| Number of pinion teeth | 8 teeth | ||||
| Performance | Voltage | Current | Torque | Revolution speed | |
| Around at 20°C (68°F) | No-load characteristic | 11.0 V | 90 A MAX | 2000 rpm MIN | |
| Loaded characteristic | 7.5 V | 300 A | 11.0 N.m (1.1 kgf-m, 8.5 lbf-ft) minimum | 840 rpm MIN | |
| Locked characteristic | 3.0 V | 860 A MAX | 20.0 N.m (2.0 kgf-m, 15.0 lbf-ft) minimum | ||
| Magnetic switch operating voltage | 8 V or less | ||||
CRANKING SYSTEM SPECIFICATIONS
Tightening Torque Specifications
| Fastening part | Tightening torque | Note | ||
|---|---|---|---|---|
| N.m | Kgf-m | Lbf-ft | ||
| Starting motor cable nut | 11 | 1.1 | 8.5 | Refer to Starting Motor Removal and Installation . |
| Starting motor mounting bolt | 45 | 4.6 | 33.5 | Refer to Starting Motor Removal and Installation . |
| Brush holder screw | 3.5 | 0.36 | 3.0 | Refer to Starting Motor Removal and Installation . |
| End frame bolt | 6.0 | 0.61 | 4.5 | Refer to Starting Motor Disassembly and Reassembly . |
| Magnetic switch screw | 6.0 | 0.61 | 4.5 | Refer to Starting Motor Disassembly and Reassembly . |
| Lead wire nut | 10 | 1.0 | 7.5 | Refer to Starting Motor Disassembly and Reassembly . |
TIGHTENING TORQUE SPECIFICATIONS
Note. The specified tightening torque is described in the following. STARTING MOTOR COMPONENTS
Reference
For the tightening torque of fastener not specified in this service information, refer to FASTENERS INFORMATION .