Contents Wiring diagrams Section: Hoist/jack All sections

General Information: Application Suzuki Equator I

Function and System Application

Diagnostic test modeFunctionEngine / PowertrainAT (1)ABS/ESP®AIR BAGIPDM E/RBCMMeter / M&ADiff Lock (2)4WD (3)
UtilityThis mode enables a technician to adjust some devices faster and more accurately by following the indications on SDT.XXX
DTC checkDTC check can be performed quickly.X
DTC check can be read and erased quickly.XXXXXXXXX
Current DTC check previously stored can be read.X
Data listInput/Output data in the ECM can be read.XXXXXXXX
Bus checkThe condition of CAN communication can be indicated by a topology.XXXXXXXXX
The communication condition of CAN communication line can be read.XXXXXXXX
Active testDiagnostic Test Mode in which SDT drives some actuators apart from the ECMs and also shifts some parameters in a specified range.XXXX
Readiness testThe results of Readiness test and the DTC check can be confirmed.XX
DTC work supportThe operating condition to confirm Diagnosis Trouble Codes can be selected.XX
C/U part numberC/U part number can be read.XXXXX
C/U Identification NumberClassification number of a replacement ECU can be read to prevent an incorrect ECU from being installed.X
Passenger AirbagDisplays the STATUS (readiness) of the front passenger air bag.X
ConfigurationSets control module parameters to match vehicle options.X
PIN read (4)This mode shows the BCM-specific 5-digit code.X
C/U initialization (4)All registered ignition key IDs in immobilizer system components can be initialized and new IDs can be registered.X
X: Applicable
(1) With automatic transmission (2) With differential lock (3) With 4-wheel drive (4) With immobilizer cable installed
(1)With automatic transmission
(2)With differential lock
(3)With 4-wheel drive
(4)With immobilizer cable installed

FUNCTION AND SYSTEM APPLICATION