Washer System & Wiper System: Other Subaru Outback BP

CAUTION

1. Reconnect connectors and hoses securely. After reconnecting, confirm that each function operates normally.
2. Be careful that wire harnesses of airbag system pass near electrical parts and switches.
3. Wire harnesses and connectors of all airbag system are yellow color. Do not use a tester on these circuits.
4. Care must be taken when installing the piping hose so that no bending, jamming, etc. are caused.
5. If even a little oil or grease such as silicon oil gets in the tank and washer passages, an oil film easily forms on the glass, causing the wiper to chatter and judder. Therefore, be careful not to let this happen.

WIPER AND WASHER (FRONT)

Refer to WIPER/WASHER , Wiper and Washer System (Front).

WIPER AND WASHER (REAR)

Refer to WIPER/WASHER , Wiper and Washer System (Rear).

WAGON

Install in the reverse order of removal.

Scheme 41

Scheme 42

1. Apply battery voltage to the rear terminals 8 and 2, and then inspect the voltage of 6 and 2. (Measure the voltage from after the second time the wiper stops.)

If operation is not as specified, replace the switch.