Home ReviewsRefund
Home/Subaru/Impreza/Subaru Impreza GH (2007-2011)/Repair manual/Cooling System (Mechanical)/Engine Cooling System (H4DOTC) (Except Sti): Overhaul
Contents Wiring diagrams Section: Cooling System (Mechanical) All sections

Engine Cooling System (H4DOTC) (Except Sti): Overhaul Subaru Impreza GH

Cooling System (Mechanical) 1 illustration ~164 words

ASSEMBLY

Assemble in the reverse order of disassembly.

Tightening torque: 4.41 N.m (0.45 kgf-m, 3.25 ft-lb)

Tightening torque: 3.4 N.m (0.3 kgf-m, 2.5 ft-lb)

Scheme 105

Scheme 105
Scheme 105
  1. Set the vehicle on a lift.
  2. Disconnect the ground cable from battery.
  3. Lift up the vehicle.
  4. Remove the under cover.
  5. Disconnect the sub fan motor connector (B).
  6. Remove the heat shield cover from radiator. (AT model)
  7. Lower the vehicle.
  8. Remove the air intake duct. Ref. to «REMOVAL»(ref-357235-S10313590332010031100000) , Air Intake Duct.
  9. Remove the bolts which secure the radiator sub fan motor assembly and the over flow pipe.
  10. Raise the radiator sub fan motor assembly slightly, remove the pin at the lower part of the radiator sub fan motor assembly from the radiator hole, and remove the radiator sub fan motor assembly from the lower side of the vehicle.

Assemble in the reverse order of disassembly.

Tightening torque: 4.41 N.m (0.45 kgf-m, 3.25 ft-lb)

Tightening torque: 3.4 N.m (0.3 kgf-m, 2.5 ft-lb)

More articles — Engine Cooling System (H4DOTC) (Except Sti)