OPERATION OF SELECT LEVER
Make sure there is no noise, dragging or contact pattern in each select lever range.
| WARNING | Stop the engine while checking operation of the select lever. |
OPERATION
Refer to "Subaru Select Monitor" for information on how to display a DTC. Refer to OPERATION, Subaru Select Monitor.
For details concerning DTCs,."List of Diagnostic Trouble Code (DTC)".. LIST OF DIAGNOSTIC TROUBLE CODE (DTC).
Refer to "Subaru Select Monitor" for information about how to clear a DTC.
Refer to CLEAR MEMORY MODE, OPERATION, Subaru Select Monitor.
When any on-board diagnostics item is malfunctioning, the ATF temperature warning light blinks. The light keeps blinking from when the malfunction is detected after starting the engine, until the ignition switch is turned OFF. The faulty parts or unit can be identified by reading DTCs. Problems which occurred previously can also be identified through the memory function. If the ATF temperature warning light does not blink when a problem actually occurs, the problem can be determined by checking the performance characteristics of each sensor using the Subaru Select Monitor. Warning light signal patterns are shown in the figure.
Scheme 57
Inspect the ATF temperature warning light when it does not operate correctly. Refer to INSPECTION, AT OIL TEMP Warning Light Display.
See also:
• LIST OF DIAGNOSTIC TROUBLE CODE (DTC)