Basic Diagnostic Procedure Chart. Scheme 668
Scheme 668: Basic Diagnostic Procedure Chart
OPERATION OF SHIFT SELECT LEVER
| WARNING | Stop the engine while checking operation of selector lever. |
Scheme 669
- Check that selector lever does not move from "N" to "R" without pushing the button.
- Check that selector lever does not move from "R" to "P" without pushing the button.
- Check that selector lever does not move from "P" to "R" without pushing the button.
- Check that selector lever does not move from "3" to "2" without pushing the button. (Scheme 669): Checking Operation Of Selector Lever
Identifying Control Module Locations (1 Of 2). Scheme 670
Scheme 670: Identifying Control Module Locations (1 Of 2)
Identifying Control Module Locations (2 Of 2). Scheme 671
Scheme 671: Identifying Control Module Locations (2 Of 2)
Identifying Sensor Locations (1 Of 2). Scheme 672
Scheme 672: Identifying Sensor Locations (1 Of 2)
Identifying Sensor Locations (2 Of 2). Scheme 673
Scheme 673: Identifying Sensor Locations (2 Of 2)
Identifying Solenoid Locations. Scheme 674
Scheme 674: Identifying Solenoid Locations
Transmission Control Module (TCM) - Connector Pin Identification. Scheme 675
Scheme 675: Transmission Control Module (TCM) - Connector Pin Identification
Transmission Control Module (TCM) - I/O Signal (1 Of 3). Scheme 676
Scheme 676: Transmission Control Module (TCM) - I/O Signal (1 Of 3)
Transmission Control Module (TCM) - I/O Signal (2 Of 3). Scheme 677
Scheme 677: Transmission Control Module (TCM) - I/O Signal (2 Of 3)
Transmission Control Module (TCM) - I/O Signal (3 Of 3). Scheme 678
Scheme 678: Transmission Control Module (TCM) - I/O Signal (3 Of 3)
Schematic Diagram. Scheme 679
Scheme 679: Schematic Diagram
OPERATION
Raise the vehicle using a garage jack and place on safety stands or drive the vehicle onto free rollers.
| WARNING | Before raising the vehicle, ensure parking brakes are applied. Do not use a pantograph jack in place of a safety stand. Secure a rope or wire to the front and rear towing or tie-down hooks to prevent the lateral runout of front wheels. Do not abruptly depress/release clutch pedal or accelerator pedal during works even when engine is operating at low speeds since this may cause vehicle to jump off free rollers. In order to prevent the vehicle from slipping due to vibration, do not place any wooden blocks or similar items between the safety stands and the vehicle. Since the rear wheels will also rotate, do not place anything near them. Also, make sure that nobody goes in front of the vehicle. |
Placing Vehicle On Safety Stands Or Onto Free Rollers. Scheme 680
Scheme 680: Placing Vehicle On Safety Stands Or Onto Free Rollers
