Note. Refer to illustration for connector and terminal identification. (Схема №11)- (Схема №29).
- With SSM or OBD-II scan tool, check for DTC P0105, P0106, P0443 or P1102. If any DTC is displayed, repair as necessary, clear codes and retest. If no DTC is displayed, go to next step.
- Turn ignition to OFF. Connect test mode connector at lower portion of instrument panel (driver's side), to the side of the center console box. Turn ignition to ON. If ON/OFF cycling of purge control solenoid is not about 0.3 Hz, replace purge control solenoid valve. If purge control solenoid cycles at about 0.3 Hz, blow through canister purge hose to check if pulsations occur. If pulsations do not occur, replace purge control solenoid valve. If pulsations occur, check and repair loose connections, cracks and clogging in evaporation line.