COOLING BLEEDING SYSTEM
Cooling system bleeding procedure is not available from manufacturer.
A/C COMPRESSOR, ALTERNATOR & POWER STEERING BELT
- Replace belts, if cracks, fraying or wear is found.
- Check drive belt tension adjust it if necessary by changing generator installing position and/or idler pulley installing position. (Scheme 1)
| Application | (1) In. (mm) |
|---|
| Alternator & P/S Belt |
| New Belt | .276-.354 (7-9) |
| Used Belt | .354-.433 (9-11) |
| A/C Belt (2) |
| New Belt | .295-.335 (7.5-8.5) |
| Used Belt | .354-.394 (9-10) |
| (1) Deflection is measured with 22 lbs. (98 N) of force applied to belt. (2) No belt on models without A/C. |
| (1) | Deflection is measured with 22 lbs. (98 N) of force applied to belt. |
| (2) | No belt on models without A/C. |
DRIVE BELT ADJUSTMENT SPECIFICATIONS - DEFLECTION METHOD
Scheme 1
Scheme 1: DRIVE BELT ROUTING
COOLING SYSTEM SPECIFICATIONS
| Application | Specification |
|---|
| Coolant Replacement Interval | (1) |
| Coolant Capacity |
| Non-Turbo |
| A/T | 7.29 Qts. (6.9L) |
| M/T | 7.4 Qts. (7L) |
| Turbo |
| A/T | 8.3 Qts. (7.6L) |
| M/T | 8.14 Qts (7.7L) |
| Pressure Cap |
| Standard | 14-18 psi (93-123 kPa) |
| Service Limit | 12 psi (83 kPa) |
| Thermostat Opens |
| Starts | 169-176°F (76-80°C) |
| Fully Open | 196°F (91°C) |
| (1) Replace coolant every 30,000 miles. |
| (1) | Replace coolant every 30,000 miles. |
COOLING SYSTEM SPECIFICATIONS
