Fastener Tightening Specifications
| Application | Specification | |
|---|---|---|
| Metric | English | |
| Front Brake Bleed Valve | 13 N.m | 115 lb in |
| Front Brake Caliper Bracket Mounting Bolt | 160 N.m | 118 lb ft |
| Front Brake Caliper Guide Pin Tighten the leading guide pin bolt closest to the bleed screw first. | 42 N.m | 31 lb ft |
| Front Brake Hose Bolt | 40 N.m | 30 lb ft |
| Rear Brake Bleed Valve | 12 N.m | 110 lb in |
| Rear Brake Caliper Bracket Mounting Bolt | 200 N.m | 148 lb ft |
| Rear Brake Caliper Guide Pin | 31 N.m | 23 lb ft |
| Rear Brake Hose Bolt | 54 N.m | 40 lb ft |
| Rear Disc Brake Backing Plate Nuts | 135 N.m | 100 lb ft |
Fastener Tightening Specifications
Disc Brake Component Specifications
| Application | Specification | |
|---|---|---|
| Metric | English | |
| Front Brakes | ||
| Rotor Discard Thickness * | 27.5 mm | 1.08 in |
| Rotor Thickness (new) | 29.0 mm | 1.14 in |
| Rotor Maximum Allowable Lateral Runout | 0.051 mm | 0.002 in |
| Rotor Maximum Allowable Scoring | 1.50 mm | 0.059 in |
| Rotor Maximum Allowable Thickness Variation | 0.025 mm | 0.001 in |
| Rear Brakes | ||
| Rotor Discard Thickness * | 18.50 mm | 0.728 in |
| Rotor Thickness (new) | 20.0 mm | 0.787 in |
| Rotor Maximum Allowable Lateral Runout | 0.051 mm | 0.002 in |
| Rotor Maximum Allowable Scoring | 1.50 mm | 0.059 in |
| Rotor Maximum Allowable Thickness Variation | 0.025 mm | 0.001 in |
| * All brake rotors have a discard dimension cast into them. Replace any rotor that does not meet this specification. After refinishing the rotor, replace any rotor that does not meet the minimum thickness specifications. | ||
General Specifications
Begin the disc brake system diagnosis with Diagnostic Starting Point - Hydraulic Brakes . The use of the Diagnostic Starting Point will lead to the identification of the correct procedure for diagnosing the system and where the procedure is located.