Washer fluid level sensor
The sensor detects low washer fluid levels and sends information to the SID when the level is low.
Reset function
To reset the trip computer functions, hold down the CLEAR button for more than 4 seconds. Resetting to zero is indicated by a brief acoustic signal at the same time as the text "CLEARED" appears on the display for 2 seconds.
| Functions concerned are | The display shows |
|---|---|
| Distance on remaining fuel | "x x x" km (miles) |
| Average fuel consumption "- - -" | |
| Average speed | "- - -" km/h (miles/h) |
TOOL COMPATIBILITY
Scheme 227
To reset the trip computer functions, hold down the CLEAR button for more than 4 seconds. Resetting to zero is indicated by a brief acoustic signal at the same time as the text "CLEARED" appears on the display for 2 seconds.
| Functions concerned are | The display shows |
|---|---|
| Distance on remaining fuel | "x x x" km (miles) |
| Average fuel consumption | "- - -" |
| Average speed | "- - -" km/h (miles/h) |
| Distance to destination | 0 m |
TOOL COMPATIBILITY
Note. The values programmed in DIST/ARRIV are not reset.
Manual reset
The service message is reset by pressing and holding the CLEAR button for at least 8 seconds. The SID gives two acoustic signals in quick succession. On the second signal "SERVICE" starts to flash. Resetting means that the service interval is recalculated and the day counter zeroed.
Automatic reset
The service message is reset automatically when it has been activated (shown) on the display 20 times.