Home ReviewsRefund
Home/Porsche/Cayenne/Porsche Cayenne I (2002-2007)/Repair manual/Automatic - Actuation, Assembly Housing/Replacing ATF
Contents Wiring diagrams Section: Automatic - Actuation, Assembly Housing All sections

Replacing ATF Porsche Cayenne I

Automatic - Actuation, Assembly Housing ~380 words

Replacing ATF

1. Remove cover of ATF pan. To do this, loosen the two fastening screws -arrows-. see scheme 23

2. Place oil collecting container underneath the vehicle.

WARNINGDanger of scalding and chemical burns from hot ATF

> Allow ATF to cool down

> Wear personal protective gear (goggles, gloves)

Note. ATF must be changed when the engine/transmission is cold.

Note. Only part of the total change quantity can be filled because of the test specifications stipulated for the ATF. The rest must then be filled as described in the Checking ATF chapter.

3. Unscrew oil drain plug -B- and drain ATF. see scheme 24

4. Screw in oil drain plug -B- with new sealing ring. --> Tightening torque: 28 (21 ftlb.) Nm see scheme 24

Note. Counter when loosening the ATF lines.

5. Undo ATF line screw connection on cooler side -arrow- at the thermostat. see scheme 25

6. Unscrew bolt -arrow- on ATF thermostat holder. see scheme 26

WARNINGDanger of scalding and chemical burns from hot ATF

> Allow ATF to cool down

> Wear personal protective gear (goggles, gloves)

7. Hold shop-made tool (material) 00000 under ATF thermostat. see scheme 27

8. Drain ATF from ATF cooler.

Note. Counter when fastening the ATF lines.

9. Tighten ATF line screw connection on cooler side -arrow- at the thermostat. --> Tightening torque: 30 (22 ftlb.) Nm see scheme 28

10. Screw in bolt -arrow- on ATF thermostat holder. --> Tightening torque: 3.5 (2.5 ftlb.) Nm see scheme 29

11. Unscrew ATF inspection plug/filler screw -A-. --> Tightening torque: 70 (52 ftlb.) Nm see scheme 30

Note. Modified ATF filling capacity in the transmission in combination with new control units. Observe --> " Technical Information Ti 01/04 Group 3" and numbers on transmission and control unit.

12. Fill with ATF using material 00000 until oil emerges at the lifting pipe. --> Change quantity: 8.5 l or --> Change quantity: 9.6 l

13. Screw in ATF inspection plug/filler screw -A-. see scheme 31

14. Install cover of ATF pan. To do this, tighten the two fastening screws -arrows-. --> Tightening torque: 10 (7.5 ftlb.) Nm see scheme 32

1. Fit engine guard. Refer to 10 80 19 Removing and installing engine guard - as of MY 2003 (All Models) .

2. Check and if necessary, top up the ATF. > 370235 Checking and topping up the ATF