Torque Converter: Removal & Installation Porsche Boxster 986 рестайлинг

REMOVAL

1. Remove transmission.
2. With transmission in horizontal position, carefully remove the converter.

INSTALLATION

Note. Check converter hub for traces of scoring. In the event of damage or faults, the complete converter must be replaced.

Scheme 5

Scheme 6

1. Grease the bearing pin of the converter with Longtime 3EP (Part No. 000.043.024.00).
2. Carefully push converter onto transmission shaft as far as the first stop. Then press converter by hand into the converter bell housing and turn it until the recess in the converter hub engages in the driver of the impeller and the converter perceptibly slides inward.

Note. If the installed position of the converter is incorrect, the ATF pump can be destroyed when the transmission is flange-mounted to the engine.

Scheme 7

TORQUE CONVERTER SEALING RING SPECIAL TOOLS

Scheme 8

1. Remove transmission and converter.
2. Remove sealing ring with special tool VW 681. Place the special tool directly behind the sealing lip of the sealing ring so that the mounting-face ring is not damaged.

Scheme 9

Scheme 10

1. Replace mounting-face ring if damaged. Torque converter Sealing ring Mounting-face ring
2. Thinly coat circumference and sealing lip of sealing ring with Vaseline and drive sealing ring home as far as the mounting face with special tool 3295.

Poses Online