Home ReviewsRefund
Home/Pontiac/Torrent/Pontiac Torrent I (2005-2009)/Repair manual/Communication Devices/Programming and Setup - All Systems: Specifications
Contents Wiring diagrams Section: Communication Devices All sections

Programming and Setup - All Systems: Specifications Pontiac Torrent I

Communication Devices ~174 words

Power Steering Motor or Torque Sensor Replacement

IMPORTANTThe power steering control module is serviced separately from the steering column assembly. However, the torque sensor is serviced as part of the steering column assembly.

After replacing either the steering column assembly or the power steering motor only the Steering Position/Torque Sensor Calibration procedure must be performed. Certain steering symptoms can be corrected by performing the Steering Position/Torque Sensor Calibration procedure such as

  1. Poor or uneven return to center
  2. Poor or uneven on center feel

Steering Position/Torque Sensor Calibration

  1. Install a scan tool.
  2. Turn ON the ignition, with the engine ON.
  3. Select Special Functions on the scan tool.
  4. Select Steering Position/Torque Sensor Calibration and press the Enter key.
  5. Center the steering wheel.
  6. Turn OFF the ignition and then ON again, with the engine ON.
  7. Turn the steering wheel 180 degrees the left and then 180 degrees to the right.
  8. Center the steering wheel.
  9. Wait until the scan tool displays "Calibration Complete". If the scan tool displays "Procedure Failed", repeat the calibration procedure.
  10. Press the Exit key.
  11. Clear any PSCM DTCs with the scan tool.
  12. Turn the ignition OFF.

More articles — Programming and Setup - All Systems