Computer/integrating Systems: Removal & Installation Pontiac GTO IV

Removal Procedure

1. Disconnect the electrical connector (2) from the (PIM) control module.
2. Remove the powertrain interface module (PIM) control module (1) from the vehicle.

Installation Procedure

1. Position the (PIM) control module (1) to the vehicle.
2. Connect the electrical connector (2) to the (PIM) control module (1).
3. The (PIM) control module (1) must be security linked to the (BCM) body control module and the (ECM). Refer to «Body Control Module (BCM) Programming/RPO Configuration»(ref-201041-S01190422912005102400000) and «Service Programming System (SPS)»(ref-201100-S18496744742005102400000) .

1. Remove the right closeout insulator/trim panel. Refer to «Closeout/Insulator Panel Replacement - Right»(ref-201046-S23783276292005102400000) in Instrument Panel, Gages and Console.
2. Remove the screw (2) attaching the BCM (1) to the bracket.
3. Release the rear retaining tab and gently remove the BCM from the mounting bracket.
4. Disconnect the 4 wiring harness connectors by pressing each connector tab and pulling the connector away from the module.

1. Align the BCM (1) to the bracket, making sure the retaining tabs are correctly located.
2. Install the screw (2) attaching the BCM (2) to the bracket. Tighten: Tighten the screw to 2 N.m (18 lb in).
3. Connect the 4 BCM electrical connectors.
4. Install the right closeout insulator/trim panel. Refer to «Closeout/Insulator Panel Replacement - Right»(ref-201046-S23783276292005102400000) in Instrument Panel, Gages and Console.
5. Perform the new BCM setup. Refer to «Body Control Module (BCM) Programming/RPO Configuration»(ref-201041-S01190422912005102400000) in Computer/Integrating Systems.
6. Program the transmitters. Refer to «Transmitter Programming»(ref-201053-S24767596122005102400000) in Keyless Entry.