Home/Opel/Vectra/Opel Vectra C (2002-2008)/Repair manual/Continuously Variable Transmission (Cvt) Front Drive/Replace Electronic Control Unit (VT20-E)

Contents

Wiring diagrams Section: Continuously Variable Transmission (Cvt) Front Drive

All sections

Replace Electronic Control Unit (VT20-E) Opel Vectra C

Continuously Variable Transmission (Cvt) Front Drive 2 illustrations

Remove

1. Open battery cover
2. Remove transmission control unit (2) • Release 2x wiring harness plug (1) and disconnect. • Clip transmission control unit with bracket out of battery case (arrow)

Note. Pull upwards.

Replace Electronic Control Unit (VT20-E)

Install

3. Install transmission control unit (2) with bracket • Clip transmission control unit with bracket into battery case • Connect and lock 2x wiring harness plug (1)

Note. Insert (arrow) into guide and press downwards.

4. Close battery cover
5. When replacing transmission control unit, run "Program" using TECH 2 after installing

Replace Electronic Control Unit (VT20-E)