Contents Wiring diagrams Section: Anti-Theft Warning System-S All sections

Table 2, Trouble Code/alarm Code Table Opel Corsa B

Table 2, Trouble Code/Alarm Code Table

Trouble CodeInformation Sensor Cause of FaultRemedy in F0:DATA LIST No.Trouble Code Storage when ...
18DISARM WIRE
OPEN CIRCUIT13, 14· Incorrect voltage level (voltage in region

1.5 to 2.6 V ± 10%) to control unit Ter.11

or

· Interruption (resistance > 3.5 kW) in wiring harness between ATWS control unit Ter.11 and door lock on driver's side (desensitize lead)

25HORN

CIRCUIT

24· Voltage to control unit Ter. 24 (horn input)

< 3.5 V ± 20%

(lead interruption, horn defective)

26TURN SIGNAL

LEFT CIRCUIT

21· Interruption (resistance > 41 kW in wiring harness between control unit Ter.12 and left turn signal units
27TURN SIGNAL

RIGHT CIRCUIT

22· Interruption (resistance > 41 kW) in wiring harness between control unit Ter.25 and right turn signal units
32TRUNK SWITCH

ALARM ACTIVATED

05· The ATWS control unit has registered an unauthorized manipulation at the "luggage compartment/tailgate" input
33ENGINE HOOD SW.

ALARM ACTIVATED

04· The ATWS control unit has registered an unauthorized manipulation at the "bonnet" input
34DOOR SWITCH

ALARM ACTIVATED

03· The ATWS control unit has registered an unauthorized manipulation at the "doors" input

Note: If the time span between "desensitizing" and opening the door is too short (< 0.5 s), an alarm code may be stored although no alarm is present.

35IGNITION ON

ALARM ACTIVATE

02· The ATWS control unit has registered an unauthorized manipulation at the "ignition Ter.15" input
36CRANK SIGNAL

ALARM ACTIVATE

11,12· The ATWS control unit has registered an unauthorized manipulation at the "starter Ter.50" input
37RADIO RECEIVER

ALARM ACTIVATE

07,08· The ATWS control unit has registered an unauthorizedmanipulation at the "radio" input
39DISARM SIGNAL

ALARM ACTIVATED

13· The ATWS control unit has registered an unauthorized manipulation at the "desensitize" input
46PANE BREAKAGE

SENSOR ALARM

ACTIV.

09,10· The ATWS control unit has registered an unauthorized manipulation at the "rear screen monitor" input (Estate only).
55REPLACE
ECU18· RAM memory of control unit defective

or

· Difference between operating voltage minus excitation lead voltage > 20%