| KM-470-B | Angular Torque Wrench |
|---|---|
| Tightening of bolted connections with additional angle | |
| KM-507-C | Remover |
| Pressing tie rod end from steering knuckle | |
| MKM-610 | Torque Wrench – 1/2" drive, range: 30 - 130 Nm |
| Tightening of bolted connections to torque | |
| MKM-611 | Torque Wrench – 3/8" drive, range: 10 - 60 Nm |
| Tightening of bolted connections to torque | |
| MKM-883-1 | Engine Bridge |
| Holding/lowering/lifting engine for removal/installation of front axle body | |
| KM-904 | Base Frame |
| To remove and install front axle body in conjunction with KM-6168 and KM-6169 | |
| KM-6168 | Centring Equipment |
|---|---|
| To remove, install and centre front axle body in conjunction with KM-904 | |
| KM-6169 | Engine/Transmission Mount |
| Positioning of the engine/transmission unit for removal and installation of the front axle body in conjunction with KM-904 and KM-6168 | |
| KM-6181 | Spring Pin |
| Fastening of steering intermediate shaft length for removal and installation of steering intermediate shaft or front axle body | |
| MKM-J-6459-B | Torque Wrench – 3/8" drive, range: 0 - 11 Nm |
| Tightening of bolted connections to torque | |
| KM-J-22610 | Clamp Pliers |
|---|---|
| To clamp boot retaining straps on steering gear side | |
| KM-6247 | Tie rod remover/installer |
|---|---|
| Removal and installation of the tie rod from/to steering gear rack |
| CH-47658 | Clamping tool |
|---|---|
| To detach fastening nuts of tie rod ends | |
