LUBRICATION SPECIFICATIONS
| Material | Condition | Specification |
|---|
| Engine Oil (1) | Ambient Temperature Less Than 0°F (-18°C) To Over 100°F (38°C) | SAE 5W-30 |
| Ambient Temperature Above 0°F (-18°C) To Over 100°F (38°C) | SAE 10W-30 |
| Engine Coolant | All | 50/50 Mix of Distilled Water & DEX-COOL |
| Coolant Supplement Sealer | With Complete Flush & Refill Of Cooling System | (GM Part No. 3634621) Or Equivalent |
| Brake Fluid | All | DOT 3 |
| Power Steering Fluid | All | GM Power Steering Fluid (GM Part No. 1052884) |
| Automatic Transaxle | All | DEXRON-III ATF |
| Key Lock Cylinders Lubricant | All | Multi-Purpose Lubricant(GM Part No. 12346241) |
| Windshield Washer Solvent | All | GM Optikleen Washer Solvent (GM Part No. 1051515) |
| Hood Latch Assembly, Pivots, Spring Anchor & Release Pawl | All | Aerosol Lubricant (GM Part # 12346293) |
| Hood & Door Hinges, RearFolding Seat, Fuel Door Hinge, Lift- gate Hinges, Power Sliding Door Cable | All | Multi-Purpose Lubricant (GM Part No. 12346241) |
| Weather Strip Lubricant | All | Dielectric Silicone Grease or Equivalent (GM Part No. 12345579) |
| (1) SAE 5W-30 preferred. Use API-approved oil W/Starburst symbol. |
| (1) | SAE 5W-30 preferred. Use API-approved oil W/Starburst symbol. |
LUBRICATION SPECIFICATIONS
FLUID CAPACITIES
| Item | Condition | Specification (1) |
|---|
| Engine Oil | Drained; With New Filter | 4.5 Qts. (3.8L) |
| Engine Coolant | With A/C: System Drained | 11.8 Qts. (11.3L) |
| Engine Coolant | W/ Rear Heater: System Drained | 13.5 Qts. (12.8L) |
| Automatic Transaxle | Pan Removed | 8.0 Qts. (7.6L) |
| Windshield Washer Fluid | Drained | 1 Gal. (0.4L) |
| Fuel Tank | Standard (SWB): Full Capacity | 20 Gal. (76L) |
| Fuel Tank | Optional (LWB): Full Capacity | 25 Gal. (96L) |
| (1) Capacities are recommended or calculated levels. Always use dipstick (if available) to measure level. |
| (1) | Capacities are recommended or calculated levels. Always use dipstick (if available) to measure level. |
WHEEL TIGHTENING
All standard wheel lug nuts should be tightened to 100 ft. lbs. (140 N.m). All compact spare tire lug nuts should be tightened to approximately 80 ft. lbs. (110 N.m). If wheels are equipped with locking type lug nuts, ALWAYS position the "Keyed" nut opposite the valve stem.
BATTERY SPECIFICATIONS
| CAUTION | When battery is disconnected, vehicles equipped with computers may lose memory data. When battery power is restored, driveability problems may exist on some vehicles. These vehicles may require a relearn procedure. See the COMPUTER RELEARN PROCEDURES article in the GENERAL INFORMATION section. |
