GAP ADJUSTMENT
- Tilt up glass lid.
- Loosen glass lid bolts, then tilt down glass lid.
- Adjust glass lid from outside of vehicle so it resembles "A-A" "B-B" "C-C" as shown in the figure. For gap adjustment "A-A" "C-C", carefully slide glass lid forward and rearward in vehicle. For gap adjustment "B-B", loosen sunroof unit assembly and shift side to side. NOTE: To prevent glass lid from moving after adjustment, lightly tighten the bolts.
- Tighten left front bolt, then right rear bolt to prevent uneven torque. Tighten remaining bolts, being careful to prevent glass lid from moving.
- Tilt glass lid up and down several times to check that it moves smoothly, and retains the adjustment.
HEIGHT ADJUSTMENT
- Tilt up glass lid.
- Loosen glass lid bolts, then tilt down glass lid.
- Adjust glass lid from outside of vehicle so it resembles "A-A" "B-B" "C-C" as shown in the figure. For height adjustment, manually raise/lower glass lid assembly until height difference is within specifications. NOTE: If necessary, shims may be added between sunroof unit assembly and roof panel to increase glass lid height adjustment range. To prevent glass lid from moving after adjustment, lightly tighten the bolts.
- Tighten left front bolt, then right rear bolt to prevent uneven torque. Tighten remaining bolts, being careful to prevent glass lid from moving.
- Tilt glass lid up and down several times to check that it moves smoothly, and retains the adjustment.