Key Switch (Insert) Check
- CHECK KEY SWITCH INPUT SIGNAL With CONSULT-III Check key switch "KEY ON SW" in DATA MONITOR mode with CONSULT-III. Refer to , " «CONSULT-III FUNCTION (BCM)»(ref-319465-S24022317362009062600000) ". When key is inserted into ignition key cylinder: KEY ON SW : ON When key is removed from ignition key cylinder: KEY ON SW : OFF Without CONSULT-III Check voltage between BCM connector and ground. TERMINALS VOLTAGE REFERENCE Connector Terminals Condition Voltage (V) (Approx). (+) (-) M18 37 Ground Key is inserted. Battery voltage Key is removed. 0 OK or NG OK : Key switch circuit is OK. NG : GO TO 2.
- CHECK KEY SWITCH Turn ignition switch OFF. Disconnect key switch and key lock solenoid connector. Check key switch. TERMINALS CONTINUITY REFERENCE Terminals Condition Continuity 1 - 2 Key is inserted. Yes Key is removed. No OK or NG OK : Check the following. 10A fuse [No. 14, located in fuse block (J/B)] Harness for open or short between key switch and fuse Harness for open or short between BCM and key switch NG : Replace key switch and key lock solenoid.