Transfer : TY30A: Maintenance Nissan Rogue I рестайлинг

Draining

1. Run the vehicle to warm up the transfer unit sufficiently.
2. Stop the engine and remove drain plug (1) and gaskets to drain the transfer oil. CAUTION: Never remove tooth contact test hole plug (2).
3. Before installing drain plug, set a new gasket. Install drain plug on transfer and tighten to the specified torque. Refer to " «EXPLODED VIEW»(ref-405886-S28115167772011062300000) ".

Scheme 17

Refilling

1. Remove filler plug (1) and gasket. Then fill oil up to mounting hole (A) for the filler plug. Oil grade and viscosity : Refer to " «FOR NORTH AMERICA : FLUIDS AND LUBRICANTS»(ref-405871-S03029356842011062300000) " (for NORTH AMERICA) , " «FOR MEXICO : FLUIDS AND LUBRICANTS»(ref-405871-S19632586962011062300000) " (for MEXICO). Oil capacity : Refer to " «GENERAL SPECIFICATIONS»(ref-405886-S31327272552011062300000) ". CAUTION: Carefully fill the oil. (Fill up for approximately 3 minutes.)
2. Leave the vehicle for 3 minutes. Then check oil level again.
3. Before installing filler plug, set a new gasket. Install filler plug on transfer and tighten to the specified torque. Refer to " «EXPLODED VIEW»(ref-405886-S28115167772011062300000) ". CAUTION: Never reuse gasket.

Scheme 18