APPLICATION ITEM
CONSULT-III can display each diagnostic item using the diagnostic test modes shown following.
| Diagnosis mode | Function description |
|---|---|
| ECU Identification | BCM part number is displayed. |
| Self-Diagnostic Result | Displays the diagnosis results judged by BCM. Refer to " DTC INDEX ". |
| Data Monitor | BCM input/output signals are displayed. |
| Active Test | The signals used to activate each device are forcibly supplied from BCM. |
| Work Support | Changes the setting for each system function. |
| Configuration | Read and save the vehicle specification. Write the vehicle specification when replacing BCM. |
| CAN Diag Support | Monitor Monitors the reception status of CAN communication viewed from BCM. |
ITEM FUNCTION DESCRIPTION
SYSTEM APPLICATION
BCM can perform the following functions for each system.
Note. It can perform the diagnosis modes except the following for all sub system selection items.
| X: Applicable item | ||||
|---|---|---|---|---|
| System | CONSULT-III sub system selection item | Diagnosis mode | ||
| Work Support | Data Monitor | Active Test | ||
| Door lock | DOOR LOCK | X | X | X |
| Rear window defogger | REAR DEFOGGER | X | X | |
| Warning chime | BUZZER | X | X | |
| Interior room lamp control | INT LAMP | X | X | X |
| Remote keyless entry system | MULTI REMOTE ENT | X | X | X |
| Exterior lamp | HEAD LAMP | X | X | X |
| Wiper and washer | WIPER | X | X | X |
| Turn signal and hazard warning lamps | FLASHER | X | X | |
| Air conditioner | AIR CONDITIONER | X | ||
| Intelligent Key system | INTELLIGENT KEY | X | ||
| Combination switch | COMB SW | X | ||
| BCM | X | |||
| Immobilizer | IMMU | X | X | |
| Interior room lamp battery saver | BATTERY SAVER | X | X | X |
| Back door open | TRUNK | X | X | |
| Vehicle security system | THEFT ALM | X | X | X |
| RAP system | RETAINED PWR | X | X | X |
| Signal buffer system | SIGNAL BUFFER | X | X | |
| FUEL LID (1) | ||||
| TPMS | TPMS (AIR PRESSURE MONITOR) | X | X | X |
| Panic alarm system | PANIC ALARM | X | ||
| (1) This item is displayed, but is not function. | ||||
| (1) | This item is displayed, but is not function. |
SUB SYSTEM SELECTION ITEMS
CONSULT-III performs the following functions via CAN communication with BCM.
| Diagnosis mode | Function Description |
|---|---|
| DATA MONITOR | The BCM input/output signals are displayed. |
| ACTIVE TEST | The signals used to activate each device are forcibly supplied from BCM. |
FUNCTION DESCRIPTION
CONSULT-III performs the following functions via CAN communication with BCM.
| Diagnosis mode | Function Description |
|---|---|
| DATA MONITOR | The BCM input/output signals are displayed. |
| ACTIVE TEST | The signals used to activate each device are forcibly supplied from Intelligent Key unit. |
FUNCTION DESCRIPTION
CONSULT-III performs the following functions via CAN communication with BCM.
| Diagnosis mode | Function Description |
|---|---|
| WORK SUPPORT | Changes the setting for each system function. |
| DATA MONITOR | The BCM input/output signals are displayed. |
| ACTIVE TEST | The signals used to activate each device are forcibly supplied from BCM. |
FUNCTION DESCRIPTION
CONSULT-III performs the following functions via CAN communication with BCM.
| Diagnosis mode | Function Description |
|---|---|
| ACTIVE TEST | The signals used to activate each device are forcibly supplied from BCM |
FUNCTION DESCRIPTION