Home/Nissan/Quest/Nissan Quest III (2003-2009)/Repair manual/Lighting System/ILLUMINATION CONTROL SWITCH

Contents

Wiring diagrams Section: Lighting System

Precautions for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER"

OUTLINE

BATTERY SAVER CONTROL

VEHICLE SECURITY SYSTEM (PANIC ALARM)

Terminals and Reference Values for BCM

Terminals and Reference Values for IPDM E/R

CONSULT-II Function (BCM)

Display Item List

CONSULT-II Function (IPDM E/R)

LOW BEAM AND HIGH BEAM

HEADLAMP (OUTER SIDE), FOR LOW BEAM

HEADLAMP (INNER SIDE), FOR HIGH BEAM

FRONT TURN SIGNAL/PARKING LAMP

COMBINATION SWITCH READING FUNCTION

EXTERIOR LAMP BATTERY SAVER CONTROL

DELAY TIMER FUNCTION

Major Components and Functions

SETTING CHANGE FUNCTIONS

CHECK BCM CONFIGURATION

Work Support Setting Item

CONSULT-II Functions

LH Turn

RH Turn

Turn Signal Indicator Lamp Does Not Operate

Parking, License Plate and Tail Lamps Do Not Turn OFF (After Approx. 10 Minutes)

POWER SUPPLY AND GROUND

INTERIOR LAMP BATTERY SAVER CONTROL

ILLUMINATION CONTROL SWITCH

Headlamp

Exterior Lamp

Interior Lamp/Illumination

All sections

ILLUMINATION CONTROL SWITCH Nissan Quest III

Lighting System 1 illustration

ILLUMINATION CONTROL SWITCH

Remove lower driver instrument panel. Refer to " «REMOVAL»(ref-239968-S35835752552006080300000) ".
Carefully lift tabs and pull illumination control switch out of lower driver instrument panel.

Installation is in the reverse order of removal.

Scheme 179

Scheme 179

Scheme 179