Home ReviewsRefund Car not listed?
Home/Nissan/Quest/Nissan Quest III (2003-2009)/Repair manual/Communication Devices/Body Control System: Removal & Installation
Contents Wiring diagrams Section: Communication Devices All sections

Body Control System: Removal & Installation Nissan Quest III

Communication Devices 1 illustration ~148 words

REMOVAL

Note. If possible, before removing BCM, retrieve current BCM configuration to use for reference when configuring brand-new BCM after installation. Refer to , " CONFIGURATION ".

Scheme 194

Scheme 194: REMOVAL
Scheme 194: REMOVAL
  1. Disconnect negative battery cable.
  2. Remove instrument panel storage bin. Refer to , " «REMOVAL AND INSTALLATION»(ref-239968-S00271703642006080300000) ".
  3. Remove instrument lower panel LH. Refer to , " «REMOVAL AND INSTALLATION»(ref-239968-S00271703642006080300000) ".
  4. Disconnect switch assembly.
  5. Remove screw and release BCM.
  6. Disconnect connectors and then remove BCM.

INSTALLATION

Installation is in the reverse order of removal.

Note. When replacing BCM, it must be configured. Refer to , " CONFIGURATION ". When replacing BCM, perform initialization of NATS system and registration of all NATS ignition key IDs. Refer to , " NVIS(NISSAN VEHICLE IMMOBILIZER SYSTEM-NATS) ". When replacing BCM, perform ID registration procedure of low tire pressure warning system. Refer to , " ID REGISTRATION PROCEDURE ".

More articles — Body Control System