Lan System: Wiring Nissan Pathfinder III

Precautions for Harness Repair

1. Solder the repaired area and wrap tape around the soldered area. NOTE: A fray of twisted lines must be within 110 mm (4.33 in).
2. Bypass connection is never allowed at the repaired area. NOTE: Bypass connection may cause CAN communication error. The spliced wire becomes separated and the characteristics of twisted line are lost.
3. Replace the applicable harness as an assembly if error is detected on the shield lines of CAN communication line.

Wiring Diagram - CAN

POWER SUPPLY, GROUND & CIRCUIT ELEMENTS -- PATHFINDER

Scheme 22

Scheme 23

Scheme 24

Scheme 25

Scheme 26

Scheme 27

Scheme 28

Harness Layout

Refer to " HARNESS LAYOUT ".