Home ReviewsRefund Car not listed?
Home/Nissan/Juke/Nissan Juke I facelift (2014-2014)/Repair manual/Lubrication System/Engine Lubrication System: Maintenance
Contents Wiring diagrams Section: Lubrication System All sections

Engine Lubrication System: Maintenance Nissan Juke I facelift

Lubrication System 3 illustrations ~316 words

DRAINING ENGINE COOLANT

Drain engine coolant and engine oil when the engine is cooled.

Draining

WARNINGBe careful not to get burned, as engine oil may be hot. Prolonged and repeated contact with used engine oil may cause skin cancer. Try to avoid direct skin contact with used engine oil. If skin contact is made, wash thoroughly with soap or hand cleaner as soon as possible.
  1. Warm up the engine, and check for engine oil leakage from engine components. Refer to " «INSPECTION»(ref-621389-S27978715872014061000000) ".
  2. Stop the engine and wait for 10 minutes.
  3. Loosen oil filler cap.
  4. Remove drain plug and then drain engine oil.

Refilling

  1. Install drain plug with new drain plug washer. Refer to " «EXPLODED VIEW»(ref-621377-S40404072632014061000000) ". CAUTION: Be sure to clean drain plug and install with new drain plug washer. Tightening torque: Refer to " «EXPLODED VIEW»(ref-621377-S40404072632014061000000) ".
  2. Refill with new engine oil. Engine oil specification and viscosity: Refer to " «RECOMMENDED FLUIDS AND LUBRICANTS»(ref-621382-S11847462522014061000000) ". Engine oil capacity: Refer to " «PERIODICAL MAINTENANCE SPECIFICATION»(ref-621389-S21114775972014061000000) ". CAUTION: The refill capacity depends on the engine oil temperature and drain time. Use these specifications for reference only. Always use oil level gauge to determine the proper amount of engine oil in the engine.
  3. Warm up engine and check area around drain plug and oil filter for engine oil leakage.
  4. Stop engine and wait for 10 minutes.
  5. Check the engine oil level. Refer to " «INSPECTION»(ref-621389-S27978715872014061000000) ".

Scheme 13

Scheme 13: REMOVAL
Scheme 13: REMOVAL
  1. Remove engine under cover.
  2. Using oil filter wrench [SST: KV10115801 (J-38956)] (A), remove oil filter. CAUTION: Oil filter is provided with relief valve. Use genuine NISSAN oil filter or equivalent. Be careful not to get burned when engine and engine oil may be hot. When removing, prepare a shop cloth to absorb any engine oil leakage or spillage. Completely wipe off any engine oil on engine and vehicle.

Scheme 14

Scheme 14: INSTALLATION
Scheme 14: INSTALLATION

Scheme 15

Scheme 15
Scheme 15
  1. Remove foreign materials on oil filter installation surface.
  2. Apply new engine oil to the oil seal contact surface of new oil filter.
  3. Screw oil filter manually until it touches the installation surface, then tighten it by 2/3 turn (A). Or tighten to specification. Oil filter: : 17.7 N.m (1.8 kg-m, 13 ft-lb)

More articles — Engine Lubrication System