FILLING Nissan Frontier D40

FILLING

1. Remove the filler plug. Fill with new oil until oil level reaches the specified limit near the filler plug hole. Oil grade and viscosity: Refer to " FLUIDS AND LUBRICANTS ". Oil capacity: Refer to " FLUIDS AND LUBRICANTS ".
2. After refilling the oil, check oil level. Set a gasket to the filler plug, then install it to the transmission. Tighten the filler plug to the specified torque. Refer to " CASE COMPONENTS " (5 M/T), " COMPONENTS " (6 M/T). CAUTION: Do not reuse gasket. see scheme 48: Checking Oil Level From Filler Plug Hole

Scheme 40

1. Make sure that fluid is not leaking from the transfer assembly or around it.
2. Check fluid level from the filler plug hole as shown. CAUTION: Do not start engine while checking fluid level.
3. Install the filler plug with a new gasket to the transfer. Tighten to the specified torque. Refer to " COMPONENTS ". CAUTION: Do not reuse gasket. see scheme 49: Checking Fluid Level

Scheme 41

1. Stop engine.
2. Remove the drain plug and gasket. Drain the fluid.
3. Install the drain plug with a new gasket to the transfer. Tighten to the specified torque. Refer to " COMPONENTS ". CAUTION: Do not reuse gasket. see scheme 50: Identifying Drain Plug

1. Remove the filler plug and gasket.
2. Fill the transfer with new fluid until the fluid level reaches the specified limit near the filler plug hole. Fluid grade and capacity: Refer to " FLUIDS AND LUBRICANTS ". CAUTION: Carefully fill fluid. (Fill up for approximately 3 minutes.)
3. Leave the vehicle for 3 minutes, and check fluid level again.
4. Install the filler plug with a new gasket to the transfer. Tighten to the specified torque. Refer to " COMPONENTS ". CAUTION: Do not reuse gasket. (Scheme 40): Checking Fluid Level