VACUUM HOSE INSTALLATION
- When connecting the vacuum hoses, they should be securely inserted onto the nipples.
- Connect the hoses correctly, using the VACUUM HOSE ROUTING diagram as a guide.
Home/Mitsubishi/Outlander/Mitsubishi Outlander I (2002-2009)/Repair manual/Testing & Diagnostics/Emission Control: Removal & Installation
Contents
Wiring diagrams Section: Testing & Diagnostics- Emission Control: Specifications
- Emission Control: Overview
- Emission Control: Removal & Installation
- Emission Control: Other
- Abbreviations
- Airbag
- Anti-Lock/traction Control
- Automatic Trans
- Axle Shafts
- Basic Trouble Shooting
- Body Electrical
- Brakes
- Cabin Air Filter
- Charging System
- Check Lists
- Clutches Manual & Hydraulic
- Communication Devices
- Cooling System (Mechanical)
- Cruise Control Systems
- Diagnostic Connector Locations
- Door Locks & Anti-Theft Systems
- Drive Cycles
- Driveline/axles
- Driveshaft & Universal Joints
- DTC Index
- Electrical
- Electrical Component Locations
- Emission Applications
- Engine
- Engine Control Systems
- Engine Performance
- Entertainment Systems
- Exhaust
- Exterior Body Panels
- Fuel System
- Fuses & Circuit Breakers
- Gauges & Instrument Panels
- Heated Glass/defoggers
- Heater
- Identification
- Ignition System
- Lubrication System
- Manual & Power Steering
- Manual Trans
- Mechanical
- Mechanical - Hydraulic
- Metric Conversions
- Mode 6
- Oem General Information
- Parking Brake System
- Reset Procedures
- Specifications
- Starter
- Steering
- Suspension Front
- Suspension Rear
- Testing & Diagnostics
- Timing Belt
- Traction Control Disable
- Transmission
- Wheel & Tire System
- Wheel Hubs
- Wiper/washer Systems