Home/Mitsubishi/Outlander/Mitsubishi Outlander I (2002-2009)/Repair manual/Body and Chassis/LEARNING PROCEDURE

Contents

Wiring diagrams Section: Body and Chassis

ON-VEHICLE SERVICE

SERVICE PROCEDURES

STANDARD VALUE

LIMIT

REFERENCE VALUE

DANGER, WARNING, AND CAUTION

VERIFY THE COMPLAINT

DETERMINE POSSIBLE CAUSES

FIND THE PROBLEM

REPAIR THE PROBLEM

VERIFY THE REPAIR

MEASURES TO TAKE AFTER REPLACING THE ECU

CONNECTOR MEASUREMENT SERVICE POINTS

HOW TO COPE WITH INTERMITTENT MALFUNCTIONS

TO COPE WITH INTERMITTENT MALFUNCTION

SIMULATION TESTS

TIRE AND LOADING INFORMATION PLACARD

VEHICLE SAFETY CERTIFICATION LABEL

ENGINE MODEL STAMPING

THEFT PROTECTION

SUPPLEMENTAL RESTRAINT SYSTEM (SRS)

WRITING PROCEDURE

INITIALIZATION PROCEDURE FOR LEARNING VALUE IN MFI ENGINE

INITIALIZATION PROCEDURE

PURPOSE

LEARNING PROCEDURE

SERVICING ELECTRICAL SYSTEM

VEHICLE WASHING

FRONT TOWING PICKUP < FWD >

REAR TOWING PICKUP < FWD >

TOWING WHEN KEYS ARE NOT AVAILABLE

SAFETY PRECAUTIONS

POST TYPE

SEVERE SERVICE

ENGINE OIL

LUBRICANTS AND GREASES

FUEL USAGE STATEMENT

GASOLINE CONTAINING ALCOHOL

GASOLINE CONTAINING METHYL TERTIARY BUTYL ETHER (MTBE)

MATERIALS ADDED TO FUEL

OIL VISCOSITY

COOLANT

1. FUEL SYSTEM (TANK, PIPE LINE AND CONNECTION, AND FUEL TANK FILLER TUBE CAP) (CHECK FOR LEAKS)

2. FUEL HOSES (CHECK CONDITION)

4. EVAPORATIVE EMISSION SYSTEM (EXCEPT EVAPORATIVE EMISSION CANISTER) (CHECK FOR CLOGGING)

8. DRIVE BELT (FOR GENERATOR, WATER PUMP, POWER STEERING OIL PUMP) (CHECK CONDITION)

9. EXHAUST SYSTEM (CONNECTIONS PORTION OF MUFFLER, MUFFLER PIPES AND CONVERTER HEAT SHIELDS) (CHECK AND SERVICE AS REQUIRED)

Engine Oil Filter Selection

15. ENGINE COOLANT (CHANGE)

Chang Coolant

19. BRAKE HOSES (CHECK FOR DETERIORATION OR LEAKS)

Rear differential Oil Check

SRS warning light check

SRS component visual check

Side impact sensors

SRS air bag control unit (SRS-ECU)

Air bag module, Steering wheel and Clock spring

Seat belt with pre-tensioner

25. TIRES (ROTATE)

All sections

LEARNING PROCEDURE Mitsubishi Outlander I

Body and Chassis ~141 words

LEARNING PROCEDURE

Start the engine and carry out the warm-up for the engine coolant temperature to reach 80°C or more. NOTE: When the engine coolant temperature is 80 °C or more, the warm-up is not needed if the ignition switch is in "ON" position once.
Place the ignition switch in "LOCK" (OFF) position and stop the engine.
After 10 seconds or more, start the engine again.
For 10 minutes, carry out the idling under the condition shown below and then confirm the engine has the normal idling. Transaxle: Neutral (P range on vehicles with A/T) Operation in ignition-related, fan and attachments: Not to be operated Engine coolant temperature: 80°C or more NOTE: When the engine stalls during the idling, check the dirtiness (on the throttle valve) of the throttle body and then perform the service from Procedure 1 again.