Home/Mitsubishi/Mirage/Mitsubishi Mirage V (1995-2003)/Repair manual/Mechanical/Installation (1.8L): Overview

Contents

Wiring diagrams Section: Mechanical

Engine Identification

Valve Clearance Adjustment

Timing Belt Adjustment

Trouble Shooting

Removal & Installation

Cylinder Head

Removal (1.5L)

Inspection (1.5L)

Installation (1.5L)

Removal (1.8L)

Inspection (1.8L)

Valve Springs

Valve Stem Oil Seals

Valve Guides

Valve Seats

Valves

Rocker Arm Assembly

Piston & Rod Assembly

Fitting Pistons

Piston Rings

Crankshaft & Main Bearings

Thrust Bearing

Cylinder Block

Engine Lubrication System

Crankcase Capacity

Oil Pressure

Disassembly & Inspection

Reassembly & Installation

General Specifications

Crankshaft, Main Bearings & Connecting Rod Bearings Specifications

Connecting Rods Specifications

Pistons, Piston Pins & Piston Rings Specifications

Cylinder Block Specifications

Engine Valves & Valve Springs Specifications

Cylinder Head Specifications

Camshaft Specifications

All sections

Installation (1.8L): Overview Mitsubishi Mirage V

Mechanical ~101 words

Clean all gasket surfaces. Install NEW cylinder head gasket so cylinder head holes match respective cylinder head gasket holes. DO NOT apply sealant to head gasket. Apply oil to threads of head bolts and to burred side of head bolt washers. Install head bolts and washers, with burred side of washer facing up. Tighten cylinder head bolts to specification, in sequence, and in a 5-step process. (Схема №6) See «TORQUE SPECIFICATIONS»(ref-8687-S42814338902000091300000).
To complete installation, reverse removal procedure. Apply gasoline to "O" ring on fuel line before installing into fuel delivery pipe. Refill cooling system. Adjust all control cables.