Home ReviewsRefund Car not listed?
Home/Mitsubishi/Lancer/Mitsubishi Lancer IX facelift (2006-2006)/Repair manual/Anti-Lock/traction Control/Active Skid Control System (Asc) - Lancer Evolution: Wiring
Contents Wiring diagrams Section: Anti-Lock/traction Control All sections

Active Skid Control System (Asc) - Lancer Evolution: Wiring Mitsubishi Lancer IX facelift

Anti-Lock/traction Control ~112 words

RESISTANCE AND CONTINUITY BETWEEN HARNESS-SIDE CONNECTOR TERMINALS

Required Special Tool

MB991997: ASC Check Harness

  1. Operate the lock lever as shown in the figure to disconnect the ASC-ECU wiring harness connector.
  2. When performing the continuity check, turn the ignition switch to LOCK (OFF) position, connect special tool ASC Check Harness (MB991997) as shown in the figure, and disconnect the ASC-ECU connector.
  3. Check for continuity between terminals shown in the chart below.
  4. Terminal layout is shown in the figure.
Terminal No.SignalNormal conditions
16 - body groundGroundContinuity exists (2 ohms or less)
47 - body groundGroundContinuity exists (2 ohms or less)

RESISTANCE SPECIFICATIONS

<< A >> ASC-ECU WIRING HARNESS CONNECTOR DISCONNECTION

Operate the lock lever as shown in the figure to disconnect the ASC-ECU wiring harness connector.

More articles — Active Skid Control System (Asc) - Lancer Evolution