Home ReviewsRefund
Home/Mitsubishi/Lancer/Mitsubishi Lancer IX (2000-2007)/Repair manual/Overhaul - Evolution: Removal & Installation/>> B << MDP SENSOR INSTALLATION
Contents Wiring diagrams Section: Overhaul - Evolution: Removal & Installation All sections

>> B << MDP SENSOR INSTALLATION Mitsubishi Lancer IX

Overhaul - Evolution: Removal & Installation 3 illustrations ~198 words

>> B << MDP SENSOR INSTALLATION

CAUTIONInstall the MDP sensor carefully not to give it a shock. Do not use the sensor that has fallen to floor or any other surface.

Scheme 188

Scheme 188: >> C << AIR CONTROL VALVE BRACKET INSTALLATION
Scheme 188: >> C << AIR CONTROL VALVE BRACKET INSTALLATION
  1. Temporarily tighten the air control valve bracket and engine hanger together with the intake manifold using a jointly fastened bolt.
  2. Tighten the bolt see scheme 1to the specified torque. Tightening torque: 23 +/- 4 N.m (17 +/- 2 ft-lb)
  3. Tighten the bolt see scheme 2to the specified torque. Tightening torque: 36 +/- 6 N.m (26 +/- 4 ft-lb)
  4. Tighten the bolt see scheme 3together with the engine hanger to the specified torque. Tightening torque: 22 +/- 4 N.m (17 +/- 2 ft-lb)

Scheme 189

Scheme 189: REMOVAL AND INSTALLATION
Scheme 189: REMOVAL AND INSTALLATION

Scheme 190

Scheme 190: >> A << EXHAUST MANIFOLD INSTALLATION
Scheme 190: >> A << EXHAUST MANIFOLD INSTALLATION
  1. Hand tighten all the exhaust manifold mounting nuts.
  2. Tighten the M8 nuts to 29 +/- 3 N.m (21 +/- 2 ft-lb) in the indicated sequence.
  3. Tighten the M10 nuts to 49 +/- 3 N.m (36 +/- 3 ft-lb) in the indicated sequence.
  4. Tighten the M8 nuts again to 29 +/- 3 N.m (21 +/- 2 ft-lb) in the indicated sequence.
  5. Finally tighten the M10 nuts and the M8 nuts to the specified torque, both in the indicated sequence. Tightening torque: 33 +/- 6 N.m (24 +/- 4 ft-lb) M8 55 +/- 10 N.m (41 +/- 6 ft-lb) M10