Home ReviewsRefund
Home/Mitsubishi/Lancer Ralliart/Mitsubishi Lancer Ralliart X рестайлинг (2012-2015)/Repair manual/Engine Mechanical - 2.0l Turbo - Lancer/<< C >> ENGINE MOUNTING BRACKET/ENGINE ASSEMBLY REMOVAL
Contents Section: Engine Mechanical - 2.0l Turbo - Lancer All sections

<< C >> ENGINE MOUNTING BRACKET/ENGINE ASSEMBLY REMOVAL Mitsubishi Lancer Ralliart X рестайлинг

Engine Mechanical - 2.0l Turbo - Lancer 3 illustrations ~155 words

<< C >> ENGINE MOUNTING BRACKET/ENGINE ASSEMBLY REMOVAL

CAUTIONWhen supporting the engine assembly with a garage jack, be careful not to deform the engine oil pan.

Scheme 263

Scheme 263
Scheme 263

Scheme 264

Scheme 264
Scheme 264

Scheme 265

Scheme 265
Scheme 265
  1. Place a garage jack against the engine oil pan with a piece of wood in between to support the engine assembly.
  2. Remove special tool MB991928 or MB991895 which was installed for supporting the engine assembly when the transaxle assembly was removed (Refer to «TRANSAXLE ASSEMBLY»(/mitsubishi/lancer-ralliart/x-2012-2015/remont/automatic-trans/#twin-clutch-sportronic-shift-transmission-tc-sst-lancer) ).
  3. Set special tool MB991454 to the engine hanger and the power steering oil pump bracket.
  4. Hold the engine assembly with a chain block.
  5. Place a garage jack against the engine oil pan with a piece of wood in between, and remove the engine mounting bracket while adjusting the position of the engine.
  6. After checking that all cables, hoses and wiring harness connectors and so on are disconnected from the engine, raise the vehicle slowly with a lift, and remove the engine assembly downwards from the engine compartment.