DIAGNOSTIC TROUBLE CODE CHART
| CAUTION | During troubleshooting, a DTC code associated with other system may be set when the ignition switch is turned on with connector(s) disconnected. On completion, check all systems for DTC code(s). If DTC code(s) are set, erase them all. When the combination meter is required to be replaced as a result of the troubleshooting, the current driving distance and number of elapsed days to be used for service reminder function must be entered into the meter after the replacement. Therefore, read "Integrated mileage for reminder," "Integrated days for reminder," "Mileage until Extra reminder," "Months until Extra reminder," and "Current Schedule" from the meter before the replacement using the special function of scan tool MB991958, and note them. For the operation method of scan tool MB991958, refer to HOW TO SET BY OPERATING THE SCAN TOOL MB991958 . If "Integrated mileage for reminder" or "Integrated days for reminder" cannot be read by the scan tool MB991958, follow the method described below. |
- For the driving distance for check warning, use the driving distance displayed on the multi information display.
- For the elapsed days for check warning, calculate the number of elapsed days from the delivery date to the customer (service remainder function start date) and current date. DIAGNOSTIC TROUBLE CODE CHART DTC No. Diagnostic item B1200 Malfunction of odometer < AWD > B1201 < FWD > B1201 Abnormal fuel information B1209 Test mode B2203 VIN not programmed B2463 The sticking of rheostat switch B2464 The sticking of meter information switch B2465 Ignition switch signal error U0019 Bus off (CAN-B) U0100 Engine control module CAN timeout U0141 ETACS CAN timeout U0151 SRS-ECU CAN timeout U0154 Occupant classification-ECU CAN timeout U0164 A/C/Heater control unit CAN timeout U0168 KOS-ECU or WCM CAN timeout U0184 Audio CAN timeout U0245 Audio visual navigation unit CAN timeout U1415 Coding not completed/Data fail
