Home/Mitsubishi/Lancer Evolution/Mitsubishi Lancer Evolution VIII (2003-2005)/Repair manual/On-Vehicle Service - 2.0l (except Evolution & Sportback)/<< F>> ENGINE ASSEMBLY REMOVAL

Contents

Section: On-Vehicle Service - 2.0l (except Evolution & Sportback)

GENERAL DESCRIPTION

Generator Drive Belt Tension Check

IGNITION TIMING CHECK

IDLE MIXTURE CHECK

CURB IDLE SPEED CHECK

LASH ADJUSTER CHECK

Bleeding lash adjuster system

REMOVAL AND INSTALLATION

<< A>> POWER STEERING OIL PUMP AND BRACE ASSEMBLY REMOVAL

<< B>> A/C COMPRESSOR REMOVAL

<< C>> RADIATOR UPPER HOSE/RADIATOR LOWER HOSE REMOVAL

<< D>> TRANSAXLE ASSEMBLY REMOVAL

<< F>> ENGINE ASSEMBLY REMOVAL

>> A << ENGINE ASSEMBLY INSTALLATION

>> C << O-RING/FUEL HIGH-PRESSURE INSTALLATION

>> D << RADIATOR LOWER HOSE/RADIATOR UPPER HOSE INSTALLATION

<< A>> CRANKSHAFT PULLEY REMOVAL

>> A << CRANKSHAFT PULLEY INSTALLATION

<< A>> CAMSHAFT SPROCKET REMOVAL

<< B>> ROCKER ARM AND SHAFT ASSEMBLY REMOVAL

>> B << CAMSHAFT SPROCKET INSTALLATION

<< A>> LOWER OIL PAN REMOVAL

<< B>> UPPER OIL PAN REMOVAL

>> C << DRAIN PLUG GASKET INSTALLATION

<< A>> FLYWHEEL BOLT < M/T >/DRIVE PLATE BOLT < A/T > REMOVAL

>> B << DRIVE PLATE BOLT < A/T >/FLYWHEEL BOLT < M/T > INSTALLATION

<< B>> CYLINDER HEAD BOLTS REMOVAL

>> A << CYLINDER HEAD GASKET INSTALLATION

>> C << CAMSHAFT SPROCKET INSTALLATION

>> D << O-RING/FUEL HIGH-PRESSURE HOSE INSTALLATION

<< A>> TIMING BELT REMOVAL

>> A << TIMING BELT INSTALLATION

>> C << FLANGE INSTALLATION

FASTENER TIGHTENING SPECIFICATIONS

All sections

<< F>> ENGINE ASSEMBLY REMOVAL Mitsubishi Lancer Evolution VIII

On-Vehicle Service - 2.0l (except Evolution & Sportback)

<< F>> ENGINE ASSEMBLY REMOVAL

After checking that all cables, hoses and harness connectors, etc., are disconnected from the engine, use the chain block to slowly lift the engine assembly upward from the engine compartment.