Home ReviewsRefund
Home/Mitsubishi/Lancer Evolution/Mitsubishi Lancer Evolution VIII (2003-2005)/Repair manual/General - Evolution/< WHEN USING A TENSION GAUGE>
Contents Section: General - Evolution All sections

< WHEN USING A TENSION GAUGE> Mitsubishi Lancer Evolution VIII

General - Evolution 1 illustration

< WHEN USING A TENSION GAUGE>

  1. Check the drive belt tension. (Refer to «DRIVE BELT TENSION CHECK»(/mitsubishi/lancer-evolution/viii-2003-2005/remont/mechanical/#on-vehicle-service-evolution__drive-belt-tension-check) .)
  2. Use a belt tension gauge in the middle of the belt between the pulleys (at the place indicated by the arrow) to measure that the belt tension is within the standard value. Standard value: 245 - 412 N
  3. If not within the standard value, replace the auto-tensioner. (Refer to «AUTO-TENSIONER CHECK»(/mitsubishi/lancer-evolution/viii-2003-2005/remont/mechanical/#on-vehicle-service-evolution) .)

Scheme 272

Scheme 272
Scheme 272