Power Steering System Flushing
| Item | Specification |
|---|
| MERCON® V Automatic Transmission Fluid XT-5-QM (or XT-5-QMC) (US); CXT-5-LM12 (Canada) | MERCON® V |
| CAUTION | Do not mix oil types. Any mixture or any unapproved oil may lead to seal deterioration and leaks. A leak may ultimately cause loss of fluid, which may result in a loss of power steering assist. |
- Remove the power steering fluid reservoir cap.
- Using a suitable suction device, remove the power steering fluid from the reservoir.
- Disconnect the power steering fluid return hose from the reservoir. Remove the clamp.
- Plug the power steering fluid reservoir inlet port.
- Attach an extension hose to the power steering return hose.
- Place the open end of the extension hose into a suitable container.
- Fill the power steering fluid reservoir with new fluid.
- Start the engine while simultaneously turning the steering wheel to lock and then immediately turn the ignition switch to the OFF position.
- Fill the power steering fluid reservoir with the approved power steering fluid.
- Repeat Steps 8 and 9, turning the steering wheel in the opposite direction each time, until the fluid exiting the power steering fluid return hose is clean and clear of foreign material.
- Remove the extension hose from the power steering return hose.
- Remove the plug from the power steering fluid reservoir inlet port.
- Install the power steering return hose to the reservoir. Install the clamp.
- Fill the power steering system. For additional information, refer to «Power Steering System Filling»(ref-293459-S39617408642008080700000) .
