Removal
- Raise window to full up position (if possible) and tape window in place. Disconnect battery ground cable. Remove inner door trim panel and protective cover.
- Support regulator arm in fixed position to prevent counterbalance spring from unwinding when motor is removed. Remove 3 motor mounting screws and motor.
Installation
- Assemble window drive motor to regulator assembly. Tighten motor-to-regulator bolts until snug (DO NOT fully tighten). Connect wiring to motor.
- Connect negative battery cable. Operate window to ensure proper gear engagement. Tighten motor-to-regulator bolts to 53-89 INCH lbs. (6-10 N.m). Install door panel and trim.
Removal & Installation
Disconnect negative battery cable. Remove door trim panel. Carefully spread retaining clips and pull switch from switch plate. To install, reverse removal procedure.