Contents Wiring diagrams Section: Automatic Trans All sections

Servicing - A/t: Maintenance Mercury Mystique I

Automatic Trans ~269 words

SERVICE INTERVALS

Check fluid level at every engine oil change. Filter change and band adjustments are not required under normal operation. Fluid change is recommended every 30,000 miles. If vehicle is operated under following conditions, replace transmission fluid every 21,000 miles

  1. In hot weather with temperature greater than 90°F (32°C), carrying heavy loads and/or in hilly terrain.
  2. Towing a trailer or using a car top carrier.
  3. In police, taxi or door-to-door delivery service.

CHECKING FLUID LEVEL

  1. Transmission or transaxle must be at normal operating temperature with vehicle on level ground. Apply parking brake, and run engine at curb idle. Shift gear selector lever through all positions, ending in PARK.
  2. Fluid level should be in crosshatch area on dipstick if checked at operating temperature. If transmission is at room temperature, fluid level should be between 2 dimples on bottom of dipstick.
  3. DO NOT overfill. Check condition of fluid for contamination and burned smell. Fully reseat dipstick.

Note. For recommended transfer case fluid, see the AUTO TRANS OVERHAUL article in AUTO TRANS OVERHAUL section.

ApplicationFluid Type
CD4EMercon (XT-2-QDX)

TRANSMISSION FLUID APPLICATION

DRAINING & REFILLING

WARNINGOn vehicles with electrical air suspension, power to air suspension system must be shut off prior to hoisting, jacking or towing an air suspension vehicle. Air suspension switch is located in left side of trunk. Failure to do so can result in inflation or deflation of air springs, which may cause vehicle to shift during these operations.
  1. Raise and support vehicle. Place drain pan under transaxle. Remove transaxle drain plug and drain fluid from transaxle. Install transaxle drain plug.
  2. Add 5 qts. (4.8L) ATF. Start engine and run at idle for 5 minutes. Shift transmission through all gears during 5 minute time period. Remove transaxle drain plug and drain fluid from transaxle.
  3. Install transaxle drain plug and tighten to specification. See «TORQUE SPECIFICATIONS»(ref-2131-S13387727422000031600000) . Add 5 qts. (4.8L) ATF. Start engine and run through all gears. Check fluid and add as required.