Jacking Points
| WARNING | Jacking contact points are identified by a triangle stamped in the unibody sheet metal. Using other areas to lift the vehicle may cause damage to the vehicle. Failure to follow these instructions may result in personal injury. |
Refer to LIFTING in this article for jacking contact points.
| WARNING | All four hoist contact points must contact the designated vehicle lifting locations, identified by a triangle stamped in the unibody sheet metal. Using other areas to lift the vehicle may cause damage to the vehicle. Failure to follow these instructions may result in personal injury. |
| CAUTION | Do not allow the hoist adapters to contact the halfshafts or front wheel driveshaft and joints, steering linkage, suspension arms, stabilizer bar, or compress the stabilizer bar link insulators. Damage to suspension, exhaust and steering linkage components may occur if care is not exercised when positioning the hoist adapters of two-post hoists prior to lifting the vehicle. |
| CAUTION | Under no circumstances should the vehicle ever be lifted by the front or rear control arms, halfshafts or front wheel driveshaft and joints. Severe damage to the vehicle could result. |
Note. Adapters may be necessary to clear vehicle components to lift the vehicle safely. The adapters must be placed at the four designated contact points. Position the adapters so they are centered on the adapter contact area.
Refer to the applicable procedure in this section to lift the vehicle.
Lifting Points-Drive-On Lift
| CAUTION | To prevent possible damage to the underbody, do not drive the vehicle onto the drive-on lift without first checking for possible interference between the upright flanges of the hoist rails and the underbody. If there is interference, the lift flanges should be modified as necessary and the approach ramps built up to provide the necessary clearance. |
Drive vehicle on lift.
Scheme 1
| WARNING | All four hoist contact points must contact the designated vehicle lifting locations, identified by a triangle stamped in the unibody sheet metal. Using other areas to lift the vehicle may cause damage to the vehicle or personal injury. Failure to follow these instructions may result in personal injury. |
Note. Adapters may be necessary to clear vehicle components to lift the vehicle safely. The adapters must be placed at the four designated contact points. Position the adapters so they are centered on the adapter contact area.
Lift the vehicle.