Engine Emission Control System: Removal & Installation Mercury Montego III

Removal and Installation

1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to «JACKING & LIFTING»(ref-232992) .
2. Remove the 4 transaxle roll restrictor brace bolts. To install, clean the bolts using a wire brush, apply new threadlock to the threads and tighten to 55 Nm (41 lb-ft).
3. Remove the bolt and the transaxle roll restrictor brace. To install, clean the bolts using a wire brush, apply new threadlock to the threads and tighten to 48 Nm (35 lb-ft).
4. Disconnect the exhaust gas recirculation (EGR) system module-to-EGR system module tube fitting. To install, tighten to 40 Nm (30 lb-ft).
5. Disconnect the EGR system module tube-to-RH exhaust manifold fitting and remove the tube. To install, tighten to 40 Nm (30 lb-ft).
6. To install, reverse the removal procedure.