Engine Emission Control System: Other Mercury Montego III

Material

MATERIAL CHART

Scheme 2

1. Remove the 4 transaxle roll restrictor brace bolts. To install, clean the bolts using a wire brush, apply new threadlock to the threads and tighten to 55 Nm (41 lb-ft).
2. Remove the bolt and the transaxle roll restrictor brace. To install, clean the bolts using a wire brush, apply new threadlock to the threads and tighten to 48 Nm (35 lb-ft).
3. Disconnect the exhaust gas recirculation (EGR) system module vacuum tube and electrical connector.
4. Disconnect the EGR system module-to-EGR system module tube fitting. To install, tighten to 40 Nm (30 lb-ft).
5. Remove the 2 bolts and the EGR system module. To install, tighten to 25 Nm (18 lb-ft).
6. To install, reverse the removal procedure.

MATERIAL CHART

MATERIAL CHART

Scheme 3

Scheme 4

1. Remove the 4 transaxle roll restrictor brace bolts. To install, clean the bolts using a wire brush, apply new threadlock to the threads and tighten to 55 Nm (41 lb-ft).
2. Remove the bolt and the transaxle roll restrictor brace. To install, clean the bolts using a wire brush, apply new threadlock to the threads and tighten to 48 Nm (35 lb-ft).
3. Disconnect the positive crankcase ventilation (PCV) valve tube from the PCV valve.
4. If equipped, disconnect the PCV valve electrical connector.
5. Rotate the PCV valve counterclockwise to remove from the valve cover.
6. To install, reverse the removal procedure.