Home ReviewsRefund
Home/Mercury/Mariner/Mercury Mariner I (2004-2007)/Repair manual/Communication Devices/Multifunction Electronic Modules: Removal & Installation
Contents Wiring diagrams Section: Communication Devices All sections

Multifunction Electronic Modules: Removal & Installation Mercury Mariner I

Communication Devices

Removal and Installation

  1. Disconnect the battery. For additional information, refer to «BATTERY, MOUNTING AND CABLES»(ref-232248) .
  2. Remove the floor console SJB cover.
  3. Remove the transmission selector lever bezel from the floor console finish panel.
  4. Apply the parking brake.
  5. Remove the parking brake lever boot from the floor console finish panel.
  6. Remove the floor console finish panel.
  7. Remove the SJB screw.
  8. Disconnect the electrical connectors and remove the SJB.
  9. To install, reverse the removal procedure. Configure the SJB. Refer to «MODULE CONFIGURATION»(ref-232246) .

More articles — Multifunction Electronic Modules