Control System (Communication Network): Diagnosis Mazda Tribute I рестайлинг

Using The Worldwide Diagnostic System (WDS) When The Original Body Chassis Electrical Module Is Not Available

1. Install the new module.
2. Connect the WDS or equivalent Tester and ID the vehicle as normal.
3. From the Toolbox icon, select and highlight: Module Programming and then highlight the module that was installed and press the check mark.
4. Select and highlight: Programmable Module Installation and then highlight the module that was installed then press the check mark.
5. Follow the on-screen instructions and turn the ignition key to the OFF position and press the check mark.
6. The WDS or equivalent Tester will retrieve the module data from the PCM and automatically download the data into the new module and display: Operation Successful - Programming Complete.
7. If the data is not available in the PCM, the WDS or equivalent Tester will display a screen stating to contact the As-Built Data Center. Contact the Mazda Technical Hotline for more information on this procedure.
8. Enter the module data (module address and line are displayed to the left of the three entry boxes) and press the check mark.
9. WDS or equivalent Tester will download the data into the new module and display: Operation Successful - Programming Complete.
10. Test the module for correct operation.

Using The Worldwide Diagnostic System (WDS) When The Original Body Chassis Electrical Module Is Available

1. Connect the WDS or equivalent Tester and ID the vehicle as normal.
2. From the Toolbox icon, select and highlight: Module Programming and press the check mark.
3. Select and highlight: Programmable Module Installation.
4. Follow the on-screen instructions and turn the ignition key to the OFF position and press the check mark.
5. Install the new module and press the check mark.
6. Follow the on-screen instructions and turn the ignition key to the ON position and press the check mark.
7. Module configuration is complete.
8. Test the module for correct operation.

KEY PROGRAMMING USING DIAGNOSTIC EQUIPMENT

Note. This procedure is used when a customer needs keys programmed into the system and not have 2 programmed ignition keys available. This procedure is also useful when programmed ignition key(s) have been lost or a new ignition switch assembly has been installed, and it is desired to erase key(s) from the passive anti-theft system (PATS) memory.

Note. This procedure will erase all programmed ignition keys from the vehicle memory and the vehicle will not start until two keys have been reprogrammed to the vehicle.

Note. 2 PATS encoded keys with the correct mechanical cut must be available to carry out this procedure. 1 or both of them may be the original keys.

Note. If additional keys are to be programmed, See KEY PROGRAMMING USING TWO PROGRAMMED KEYS . If the remaining keys are not available with the vehicle, instruct the customer to see the for instructions on programming the remaining keys.

1. Turn the ignition from OFF to ON.
2. Using the WDS. or equivalent Tester, follow the SECURITY ACCESS to obtain security access. See «ANTI-THEFT SECURITY ACCESS»(ref-222005-S18574181132006022600000) .
3. From the WDS or equivalent Tester menu, select IGNITION KEY CODE ERASE. NOTE: Do not select any additional commands from this menu.
4. Turn the ignition OFF and disconnect the WDS or equivalent Tester.
5. Insert the first encoded key into the ignition and turn the ignition to ON for 1 second.
6. Insert the second encoded key into the ignition and turn the ignition to the ON position for 1 second.
7. Remove the second encoded key from the ignition.
8. The vehicle should now start with both ignition keys.