- Start the engine and inspect each exhaust system component for exhaust gas leakage. If there is leakage, repair or replace the appropriate component.
| WARNING | A hot engine and exhaust system can cause severe burns. Turn off the engine and wait until they are cool before servicing the exhaust system. |
Scheme 1
- Remove in the order indicated. (Scheme 1)
- Install in the reverse order of removal.
Scheme 2
- Remove the heated oxygen sensor using the SST.
Scheme 3
Scheme 4
Scheme 5
- Attach the SST and support the engine.
- Remove the engine mount rubber (LH) installation nut.
- Remove in the order indicated. (Scheme 4)
Scheme 6
- Tighten the A part indicated in the figure, and then pull up the engine to remove the engine mount rubber (RH).