REMOVAL & INSTALLATION
Note. If equipped with audio anti-theft system, before disconnecting battery cable, obtain radio code number from customer and deactivate audio anti-theft system.
| CAUTION | When battery is disconnected, vehicle computer and memory systems may lose memory data. Driveability problems may exist until computer systems have completed a relearn cycle. |
Wrap tape around end of flat-blade screwdriver. Carefully pry main switch out of door with screwdriver. Disconnect main switch electrical connector. To install, reconnect main switch electrical connector. Press main switch into door until lock tabs engage.
Wrap tape around end of flat blade screwdriver. Carefully pry sub-switch out of door with screwdriver. Disconnect sub-switch electrical connector. To install, reconnect sub-switch electrical connector. Press sub-switch into door until lock tabs engage.
Fully open window. Raise window until height of glass (measured at top rear edge) is as specified. See WINDOW HEIGHT SPECIFICATIONS . Disconnect negative battery cable. Remove door trim panel and water shield. Disconnect window motor electrical connector. Remove window regulator and motor as an assembly. Securely position regulator arms in full-up position (if possible) to relieve spring pressure. Remove window motor from regulator. To install, reverse removal procedure.